Wireless CarPlay Adaptor Firmware Upgrade

To remedy most issues we recommend following these steps to update the firmware of the Wireless CarPlay Adaptor:

  • Connect the CarPlay Adaptor to a USB power supply (not your car). Wait for the LED to turn RED.
  • On your iPhone, go to Settings > Display & Brightness and set Auto-Lock to "Never" (temporary for the update).
  • Connect your iPhone to the "QUADLOCK" Wi-Fi network (password: 12345678). The LED should turn GREEN.
  • Open your browser and go to 192.168.50.2.
  • Click "Check for Updates" and wait without pressing any buttons or moving the device until the update is complete.
  • After the update, wait for 5 minutes before turning the device off and on again.
  • Reconnect to Wi-Fi, go back to 192.168.50.2, and check that the software version reads: 2023.10.19, this may take a few more updates to reflect this version.

If this doesn't resolve your issue please reach out to our Support team for further assistance here.

Was this article helpful?
15
(5 out of 15 found this helpful)

Comments

(0 comments)

Leave a comment